Teenage Engineering ZM-1 Oplab Module Expansion Accessory Kit for OP-Z Bluetooth Synthesizer Sequencer

Teenage Engineering ZM-1 Oplab Module Expansion Accessory Kit

The ZM-1 Oplab Module provides you the power and flexibility to link the Teenage Engineering OP-Z Bluetooth Synth to other music equipment. This is the first hardware expansion module of Teenage Engineering, which can be mounted at the back of OP-Z. To install the Oplab Module, make sure first the OP-Z and Oplab Module are turned off. Rotate OP-Z’s yellow rubber bumpers (located at the back) 90 degrees counterclockwise. After removing the backplate, take off the lego shaft and dummy module inside OP-Z. You can use the lego shaft as a mini stand. Insert ZM-1, where you removed the dummy module. Make sure that the bottom switch of ZM-1 is flipped down to lock it in place.

You can use ZM-1 to connect the OP-Z to an analog modular synth, MIDI drum pad/keyboard/synth, or Pocket Operator by using a standard CV and gate. The Oplab Module features 3 CV outputs and 1 gate output, which can all be programmed and played from OP-Z.

NOTE: Read the user’s guide first to avoid blowing the Oplab or your other gear. Always check Teenage Engineering’s page for the latest ZM-1 firmware.

BOX CONTENTS:ZM-1 Oplab ModuleMIDI Adapter CableUser’s Guide
TECHNICAL SPECS: Ratings: 0 to +5V CV Out | -5 to +5V CV 2/3 Out | 0 to +5V Gate Out | 0 to +5V MIDI Out | 0 to +5V Trig Out | 0 to +5V PO Out | -10 to +10V MIDI In | -10 to +10V Trig In (NOTE: Do not go beyond the max ratings to avoid short-circuit)Compatible With: OP-Z, Pocket Operators, Analog Modular Synth, MIDI Synth/Keyboard/Drumpad

Product Features

• CONNECTS OP-Z TO OTHER MIDI GEAR – The small Teenage Engineering ZM-1 Oplab Module provides convenient connectors that allow you to link the OP-Z Synthesizer with MIDI keyboards, drum pads, and synths.
• CAN LINK TO ANALOG SYNTHS TOO – There are 1 Gate and 3 CV outputs, which enable you to connect OP-Z to analog modular synthesizers.
• SYNCS WITH POCKET OPERATORS – The Oplab Module is also compatible with various PO models. You can select the PO switch located at the bottom of “Mode Out.”
• EASY INSTALLATION – You can simply install ZM-1 at the back of OP-Z Bluetooth Synthesizer. No need for external mounting tools.
• INCLUDES – ZM-1 Oplab Module. User’s Guide (NOTE: Read the instructions first for the appropriate voltage ratings). MIDI Adapter Cable for 5-Pin MIDI Connectors.